![]() ![]() Also check to see if that powered tool has a setting on the trigger for single-fire only (until the trigger -and- the safety nosepiece both are released and reset) as opposed to slam-fire/sequential-fire mode (many pneumatic nailers/hammer/staplers have those two firing modes). If you lightly hold the tool and lightly squeeze the trigger, the tool will often rebound off the workpiece when you first trip the trigger and then your ‘slow’ muscles push the tool against the work again and then your finger trips the trigger again and the cycle repeats. Instead of “just barely squeezing the trigger”, get the tool into position, push it FIRMLY against the workpiece, and then quickly and firmly squeeze the trigger. Stanley TRE550 Heavy Duty Electric Staple /Nail Gun. Make sure that the staples are facing the correct way before inserting them. Insert a strip of staples into the loading chamber. This is typically located on the back of the staple gun. STANLEY ELECTRIC STAPLER / NAIL GUN CORDED TRA700 SERIES. Here I will show you how to load a Stanley staple gun in seven easy steps. ![]() That usually means you have to push down onto the stapler right over where the staple is going into the work to help make sure that the stapler is tight against the workpiece and that it stays that way while the staple is being driven in (in the blink of an eye). STANLEY Pro SharpShooter TRE500 Electric Staple / Nail Gun Kit Brads Staples USA. If the energy that was trying to drive the staple into the work instead goes into pushing the stapler UP, then the staple often doesn’t drive in fully because of the ‘lost’ energy and because the stapler is now off of the workpiece. With most staplers, you have to make sure that they don’t rebound off the work surface as you are trying to get the staple to go -into- the workpiece.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |